Jiangsu compressed air energy storage plan implemented, wide-load compressor ranked first

November 16, 2026

Jiangsu compressed air energy storage plan implemented, wide-load compressor ranked first

The Jiangsu Provincial Department of Industry and Information Technology and three other departments recently jointly issued the "Action Plan for High-Quality Development of Jiangsu Province's New Energy Storage Industry," listing compressed air energy storage as a key supported long-duration energy storage route. In the technology research list, "100 MW-level and above wide-load compressors" are listed first among core equipment directions, alongside high-load turbine expanders and high-efficiency thermal storage heat exchangers.

The operating logic of compressed air energy storage determines the compressor's position: during off-peak periods, air is compressed to store energy; during peak periods, the air is released to drive the expander to generate electricity. The compressor is the "heart" of the entire system, and its discharge temperature, pressure ratio, and wide-condition adjustment capability directly determine energy storage efficiency. The difficulty of wide-load compressors lies in "wide" — load fluctuates significantly during charging and discharging, and the compressor must maintain acceptable efficiency and stability under conditions far from the design point.

The policy side places wide-load compressors at the top of the research agenda, and the corresponding engineering foundation has already emerged. The 300 MW-class compressor unit of the Huai'an salt cavern compressed air energy storage project has been selected for the National Energy Administration's sixth batch of first-of-its-kind equipment list; this is the only compressed air energy storage item nationwide in this batch. Unit 1 has already operated at full load, and Unit 2 has been connected to the grid and put into operation.

For the compressor industry, the signal is not in the document itself, but in the fact that demand is converging from "being able to build compressed air energy storage units" to "building compressed air energy storage units with acceptable efficiency under wide-load conditions."